Starting Point

Some gerneral impressions of my starting point:

 Notice the milling motor is still on top:

z-stage:

x-stage:

 y-stage:

 Stepper testing with generation 6 electronics. With 12 Volt the steppers start to loose steps at around 230 mm/min. This far too slow. I expected much more with the 2 mm inclinded spindle. With 24 Volt I can savely read around 300 mm/min. Still dead slow. I will use is as a starting point and will also layout my extruder for 24 Volt and later use better stepper motors.