The easiest way to remove the parts is to wait until the bed cooled down to 60 degree and then use a knife to start lifting the corners. It pops off pretty easy. So far the ABS sticks well to the kapton tape.
Dienstag, 1. März 2011
Getting things done
I am still playing around with vaious parameters to get the best results. A big help was the heated bed. With the 150 Watt I can reach around 130 degree. At this temperature I print the first layer and then get down to 110 degree. I was able to print the first flat parts withour any wraping issue.
The easiest way to remove the parts is to wait until the bed cooled down to 60 degree and then use a knife to start lifting the corners. It pops off pretty easy. So far the ABS sticks well to the kapton tape.
The easiest way to remove the parts is to wait until the bed cooled down to 60 degree and then use a knife to start lifting the corners. It pops off pretty easy. So far the ABS sticks well to the kapton tape.
Abonnieren
Kommentare zum Post (Atom)
Keine Kommentare:
Kommentar veröffentlichen